How to Install Enventur Tie Downs for Secure Crate Setup

Quick Answer

To install Enventur Tie Downs, attach the straps to your crate's anchor points, route them through the vehicle's cargo tie-down loops, and tighten evenly until the crate has no visible movement. This setup preserves the crash-tested safety performance of your Enventur crate.

Step-by-Step Installation Guide

1. Position the Crate: Place your Enventur crate in the desired location inside your vehicle, typically in the cargo area. Make sure the crate is oriented so the door faces the rear or side for easy access. Common mistake: Placing the crate too close to the seatbacks, which can prevent the straps from reaching the vehicle's tie-down loops. Leave at least 2 inches of clearance around the crate for strap access.
2. Locate the Vehicle Tie-Down Points: Identify the metal tie-down loops or anchor points built into your vehicle's cargo floor or side panels. Most SUVs, vans, and trucks have them near the rear seats or along the cargo area edges. Common mistake: Using seatbelt anchors or non-rated points that may not handle the force of a crate in a crash. Only use dedicated cargo tie-down loops rated for your vehicle's load capacity.
3. Attach the Straps to the Crate: Hook the Enventur Tie Down strap's metal clip onto the crate's designated anchor point (usually a reinforced loop or bar on the crate's base). Repeat for all four corners. Common mistake: Attaching the strap to a non-reinforced part of the crate, which could bend or break under load. Verify each clip is fully closed and seated on the anchor point.
4. Route the Straps Through Vehicle Loops: Pass the free end of each strap through the corresponding vehicle tie-down loop, then back toward the crate. Use the slider on the strap to control excess webbing. Common mistake: Routing the strap around sharp edges or under seats where it can chafe or get pinched. Keep strap paths straight and clear of any sharp metal or moving parts.
5. Tighten Evenly: Pull the free end of each strap to tighten, working in a crisscross pattern (front left, rear right, etc.) to keep the crate centered. Tighten until the crate has no visible movement when you push it from any side. Common mistake: Overtightening one side, which can tilt the crate and reduce stability. After tightening, give the crate a firm shake—if it shifts, re-tighten the looser straps.
6. Secure Excess Strap: Use the slider to bundle and secure any leftover strap length so it doesn't flap or get caught. The padded buckle helps reduce noise from the strap against the crate. Common mistake: Leaving long loose ends that can snag on cargo or pets. Tuck the excess strap under the crate or use a Velcro wrap if available.

Product Facts

• Enventur Tie Downs: Heavy-duty, weather-resistant straps with rust-proof metal buckles and a padded buckle to reduce noise. The weather-resistant materials and padded buckle make the tie downs durable and quiet, so you can install them once and leave them in place without worrying about corrosion or rattling during drives.